Hi All,

Been away from my project for quite a few months and have now restarted it and could use some help

I need 2 Z shaped peices of copper forming for the brakes. I need them about 10cm long formed into a Z shape with a male fitting on one end to go into the brake cylinder and a female end on the other.
I am doing the rest of the brakes in braided hose but need these peices in copper

Can anyone help and if so, how much to make them?

many thanks

What thread sizes ?

Have you tried MK. The bits you describe sound a lot like the bits you get in the deluxe kit, that go from the rear flexy's to the rear drums.

They may be able to help.

Mike

OK mate just let me know where to post them.



You OK to bend them into a Z ?

Regards

Rich

Sent you a pm. Thanks very much.