Hello my little popsicles,

Does any one know of a supplier for weldable threaded inserts for use in the ends of wishbone tubes to take a rod end?

Or will I have to make them?

Cheers

Chris

mcgill motorsports on ebay

or rally design.

mcgills ones look like just a theaded peice of metal, rall design ones are like a top hat shape, 1" at the widest, don't know what the narrowest is, but if you get the right wall thickness tube they fit nice and snug. i think the tube i got was like 2mm wall, maybe a bit more

Chris, there are a few US manufacturers of those...U2U me if you need the info.

Alan

Thanks chaps, I like the look of the Rally design ones but it doesn't look like you can get different outside diameters so I don't know how they'd match up with the wishbone tube sizes I've got.

I've emailed them.

cheers

Chris

how many do you need and what size of tube are you using as i am going to have to run a load off for ourselves so could tag onto that if you want

cheers

marc

what tube are you using for the wishbones?

I'm using 25mm o/d, 2mm wall seamless, so I need a 21mm insert, I'd prefer the top hat type.

Marc, I need a grand total of four!

With a half inch UNF thread.

I'll mail you.

cheers

Chris

the tube i used seems to be 20mm i.d but i actaully measured the wall as well, and worked that you to be 2.6mm so kinda confused now, but i bought the tube to fit the inserts snugly,

quote:

---

I'm using 25mm o/d, 2mm wall seamless, so I need a 21mm insert, I'd prefer the top hat type.
Marc, I need a grand total of four!

With a half inch UNF thread.

---