Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Brake pipes - right angled connection / banjo.
lsdweb

posted on 25/10/05 at 12:34 PM Reply With Quote
Brake pipes - right angled connection / banjo.

hi All

I've just fitted rear calipers (see separate threads) and the brake hose entry to one of the calipers is pretty close to the panhard rod mounting. I can get acopper pipe with a bend in no problem, but I'd like to use the braided hoses I have directly into the caliper. The fitting is metric (8mm).

Does anybody do an 8mm banjo fitting - I've found loads of 10mm but can't find anybody doing 8?

Regards

Wyn

View User's Profile View All Posts By User U2U Member
JAG

posted on 25/10/05 at 12:53 PM Reply With Quote
Are you sure it's 8mm pipe thread??

10mm is much more common.





Justin


Who is this super hero? Sarge? ...No.
Rosemary, the telephone operator? ...No.
Penry, the mild-mannered janitor? ...Could be!

View User's Profile View All Posts By User U2U Member
zzrpowerd-locost

posted on 25/10/05 at 01:05 PM Reply With Quote
Goodridge do straight 8mm ones, maybe ask them bout 90 degree ones

Do stuff thats not in catalogue






View User's Profile E-Mail User View All Posts By User U2U Member
lsdweb

posted on 25/10/05 at 02:22 PM Reply With Quote
I'm confused!

They're definitely not 8mm! Closer to 10mm. Possibly 3/8" UNF but I don't think so! How do I check? None of my measurements are helping! As the calipers are Peugeot, I'd guess they are metric?

Wyn

View User's Profile View All Posts By User U2U Member
NS Dev

posted on 25/10/05 at 02:55 PM Reply With Quote
surely should be M10 x 1??

.............unless the French have done a corker and used M9 fine!! te hee!!

They use M7 for bleed nipples, but then so do a few others too!

[Edited on 25/10/05 by NS Dev]

View User's Profile Visit User's Homepage View All Posts By User U2U Member
rusty nuts

posted on 25/10/05 at 05:30 PM Reply With Quote
As NS Dev says likely to be 10mm. x 1 . Cant say thet I've ever come across an 8mm pipe nut except on perhaps Citroen systems
View User's Profile View All Posts By User U2U Member
bob

posted on 25/10/05 at 05:51 PM Reply With Quote
I had my rear braided pipes with banjo ends at caliper made up by thinkautomotive in isleworth middlesex,worth giving them a call when you find out the thread size to see if they can help.

http://www.thinkauto.com

I think they were £10 each

Mention the site for possible discount






View User's Profile View All Posts By User U2U Member
lsdweb

posted on 27/10/05 at 08:42 PM Reply With Quote
Thanks All

Definitely 10mm X 1

I was having yet another senior moment!

Wyn

View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.