Thinking about it
|
| posted on 18/3/07 at 10:13 AM |
|
|
Sierra driveshaft shortening
Any advice on the above.
How to or anyone who can do it.
|
|
|
|
|
Bluemoon
|
| posted on 18/3/07 at 11:21 AM |
|
|
Cut, sleve then weld. Not sure I would recomend doing this yourself unless your a good welder, others will be along soon to show you how..
Dan
|
|
|
rusty nuts
|
| posted on 18/3/07 at 11:30 AM |
|
|
Look at very recent posts??
|
|
|
R1 STRIKER
|
| posted on 18/3/07 at 09:17 PM |
|
|
Would be worth giving RAW a call as shortened sierra shafts are used on the striker. These are supplied on an exchange basis. I'm sure they
could supply them to the length you need, at what cost I don't know.
Hope this helps.
Ben.
|
|
|
.jpg)
