oadamo
|
| posted on 7/7/07 at 10:46 AM |
|
|
p100 pickup axle
hi at a scrapyard by me theres a p100 pickup with a good axle and prop would this be any good for a locost.
adam
|
|
|
|
|
mookaloid
|
| posted on 7/7/07 at 11:16 AM |
|
|
Not sure the stud pattern will be ok - I think they are 5 stud.
The width may be an issue - you need to measure it
The ratio might be quite good if you are putting a car engine in - commercial vehicles tend to have a low ratio which will give quicker
acceleration.
Cheers
mark
"That thing you're thinking - it wont be that."
|
|
|
gazza285
|
| posted on 7/7/07 at 01:24 PM |
|
|
Trouble with the P100 is the weight as the walls are very thick, it will work, but there are much better alternatives.
DO NOT PUT ON KNOB OR BOLLOCKS!
|
|
|
delboy
|
| posted on 7/7/07 at 08:27 PM |
|
|
definately a 5 stud wheel required, kind of limits things a lot if your using cortina or sierra front hubs.
|
|
|
