Nosbod
|
| posted on 30/11/07 at 09:38 PM |
|
|
Brake reservoir fouling bulkhead
Hi all,
I attempted to fit my master cylinder today (off a Sierra) but because of how the reinforced bulkhead has been welded (slightly inboard of the rest of
the bulkhead) the brake reservoir fouls on it.
Can i simply turn the reservoir around through 180 degrees as it fits like this or will this cause problems?
Or should I just bite the bullet and make a spacer and mount it the right way round?
Thanks in advance.
Chris.
[Edited on 30/11/07 by Nosbod]
|
|
|
|
|
Avoneer
|
| posted on 30/11/07 at 09:53 PM |
|
|
Couple of washers on each bolt between the MC and bulkhead will do.
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
|
rusty nuts
|
| posted on 30/11/07 at 10:01 PM |
|
|
Fiat connectors as in a recent post and a remote reservoir?
|
|
|
bigrich
|
| posted on 30/11/07 at 10:29 PM |
|
|
Nosbod like you said just turn it around
.JPG)
A pint for the gent and a white wine/fruit based drink for the lady. Those are the rules
|
|
|
Nosbod
|
| posted on 1/12/07 at 06:16 PM |
|
|
Thanks for the advice guys, now i can get on with routing the pipes. 
|
|
|
%20(WinCE).JPG)
.jpg)
