stuart_g
|
| posted on 4/6/08 at 05:08 PM |
|
|
Bias bar lock nuts
Anyone know where to get lock nuts to lock bias bar, they need to have a step in them so they do not lock against the clevis but the barrel part
instead. Have tried local fasteners but no joy.
|
|
|
|
|
markyb
|
| posted on 4/6/08 at 05:26 PM |
|
|
if it is for SVA Car Builders Solutions do something that might suit
try here
|
|
|
stuart_g
|
| posted on 4/6/08 at 05:57 PM |
|
|
Thanks for that. I was looking for a nut and sleeve as one piece. I have nuts and roll pins I think I will make the sleeve cause at £6 that's a
rip off 
|
|
|
indykid
|
| posted on 4/6/08 at 08:03 PM |
|
|
quote:
Originally posted by markyb
if it is for SVA Car Builders Solutions do something that might suit
try here
isn't that 15mm copper pipe a roll pin and a 7/16ths unf nut?
robbing b*st*rds!
tom
|
|
|
Johneturbo
|
| posted on 12/6/08 at 04:52 PM |
|
|
looking at carbuilders solution, wouldn't you need 2 nuts to lock it, one at each end?
i've got some 7/16 unf half nuts i was just going to put one at each end and rolepin them. would i need a sleeve?
|
|
|
richardh
|
| posted on 13/6/08 at 08:53 AM |
|
|
guys
i got away with 2 nylocks that i cut in half to make thinner and then just drilled 2 holes in the ends of the bar outside of ther buts and put split
pins in
passed no probs
|
|
|
 (WinCE).JPG)
