I must be being thick with this one but....I've just taken delivery of some nice shiney Cobras from Cashy.
I went for the runners aswell, how do you get the runner screwed to the seat? I don't want to damage anything but there doesn't seem to be any holes.
I currently have fixed fibreglass seats which are secured to a cradle then screwed to the floor. (if this helps)
Any help would be appreciated from anyone who has fitted Cobras before.

Cheers

Darth

Feel along the bottom flat surface of the seat and you will feel a small hole about 10mm below the surface of the vinyl, this has a threded fixing. They tend to trim the vinyl over the fixing holes and not punch it out after.

I found the seat a little high on runners so the drivers one is fixed to the floor and the passenger one on runners so I can store stuff behind it.

Thanks zetec, I'll get feeling this afternoon

Cheers

Darth

Hi darth,

Yes there are four threaded holes on the base of the roadster seat, may be covered by a little vinyl.

GET FEELING MATE

Well they're in, thanks to Cashy for his service.
http://www.locostbuilders.co.uk/photos.php?action=showphoto&photo=MK%20Indy%20020small.jpg




[Edited on 23/3/06 by Darth Blader]

[Edited on 23/3/06 by Darth Blader]

[Edited on 23/3/06 by Darth Blader]