Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Sierra rear drums (1.3) are they backplates handed?
MikeR

posted on 3/8/20 at 06:53 PM Reply With Quote
Sierra rear drums (1.3) are they backplates handed?

Surprised as I've been building up my rear drum brakes from 1.3 Sierra. I expected to have a left and right backplates. What I've got is two identical plates. This means the handbrake goes to the rear of the car nearside and towards the front off side.

This doesn't seem right, is it?

Does anyone know of back plates from other asked will fit (I have escort 9"and Capri 9".)

View User's Profile View All Posts By User U2U Member
snapper

posted on 3/8/20 at 07:14 PM Reply With Quote
I’ve redone the post as I was talking bol***s
The brake shoes are symmetrical and work in either side. I think the back plates are the same and you can swap them but the handbrake cable does not go in from the rear, they both go in the front.


[Edited on 3/8/20 by snapper]





I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)

View User's Profile View All Posts By User U2U Member
Dingz

posted on 4/8/20 at 01:49 PM Reply With Quote
I've replaced my shoes recently, it's hard to tell with it all reassembled but they may be symmetrical, the brake cable goes in from the front and there is a funny push button 'adjuster' that fits into what could be the symmetrical hole at the rear if that makes sense?





Phoned the local ramblers club today, but the bloke who answered just
went on and on.

View User's Profile View All Posts By User U2U Member
MikeR

posted on 4/8/20 at 01:58 PM Reply With Quote
So if both sides have the cable going into the back plate from the front. They must have a left and right back plate. The fact I've got one from the front and one from the rear means I've got an odd set

(FFS)


I've had these parts for a good 15 years.

View User's Profile View All Posts By User U2U Member
Dingz

posted on 4/8/20 at 09:54 PM Reply With Quote
I tried to explain that the plate has two symmetrical looking holes, the cable goes into the forward one and press button thing goes into the rear one. Can you post a picture of what you have?





Phoned the local ramblers club today, but the bloke who answered just
went on and on.

View User's Profile View All Posts By User U2U Member
MikeR

posted on 5/8/20 at 07:13 AM Reply With Quote
I normally get to go in the garage late in the evening, and have a cider whilst there.

Your absolutely right and everything is fine 🙂

View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.