Just dropped in my engine this morning to find out the plenum would not fit. So I know this would not fit a GBS zero. It is the rear facing one. Pictures have been uploaded into my archives in the for sale folder. £120 + postage

I have two zetec head gasket. both MLS. Bought them off this forum. With new cylinder head boths - £30 ono for the lot + postage.

Femi I am after a head gasket if its a 2.0

its a 2.0 litre one. BGA gasket

can you not cut the inlet tubes and turn the plenum round and re weld it

I can't weld that well. so I dont't even want to try. Also the tube go into the plenum

[Edited on 16/1/11 by femster87]

GBS have a pre production inlet plenum, looks a real nice piece too, they are just waiting to dyno it to see results but apparently (according to Richard) they have had really good results from it on the red demo, still not sure when it will be "for sale" though. Might be worth talking to Richard and asking, he didnt know last week but he was trying to pack up for the show when I was hassling him!!!

u2u pelnum chamber

All SOLD.

Thanks