Selling owing to (yet more) changes of plan:

2 x DRD Racing Uprights (One with bracket welded on to accept Elise Caliper)
2 x DRD Alloy Hubs drilled to accept either 4x100mm Vaux or 4x108mm Ford
2 x 250mm Custom Stainless Discs (Water cut and CNCd flat) - fit under 13" wheels with Elise Caliper - quite expensive really - oops.
All bearings and bolts to fit the above with grease caps etc plus any bits I can find which are useful!

Pics show the parts assembled inside a 13" 0 offest wheel with elise caliper - but those bits arent for sale.....yet!

The parts were bought from here:

http://www.drdracing.co.uk/Front_End.php

£150 for the lot + postage or collect from me in Northumberland.

Thanks for looking and mail any Q's across, Geoff

How close to cortina geometry are they? Any ideas on weight / saving? Price on postage?

Cheers, Adam

Adam,

I havent got any cortina uprights to compare them too but I would imagine they are similar perhaps with a bit more KPI.

Postage would be no more than £20.

I measured the weight of sierra bits as:

Caliper inc pads - 4.6kg
Disc - 5.3kg
Upright 5.5kg

I think with elise caliper and pads it was less than half that of the sierra set up.

I'll weigh the disc, upright and hub if thats helpful?

Geoff

That would be brill! I've got the cortina ones sat on my floor so can weigh them to compare. Was going to make my own but if these are suitable then it would be silly not to have them at that price.

are these still for sale regards jonny