Well i have a haynes chassis im selling. It was made by a local Fabricators then i added steel floor and rear into it. Ive cut away some of the tubes at the front ready for the bike engine cradle to drop in. And the front of the passenger footwell ive moved back to get the engine in close. it was built to take a V6 engine so is very stong and has a wide tunnel.

Needs a little bit of work to put back a few box sections if you want to fit a car engine in it.

It can be collected from my house in lincolnshire (near scunthorpe)

i know its a random amount too lol

are the suspension brackets fitted? if so i'll take it.

yes its been running with a pinto engine in it.

i got the chassis built and put a pinto in it then decided i wanted to go BEC which i did then i cut the engine bay to be wider which meant i removed the diagnal box section which the bottom of the pinto rested on. then started moving the passenger footwell back a bit.

needs painting again as i hammerited it last summer but its scuffed alot now.

Ill take it then please, collection friday evening / weekend ok with you?

[Edited on 28/11/11 by carlknight1982]

either is fine :O)

Out of curiosity Jossey, why £50.18 ?

A case of why not ??????

Well nige I was
Going to put 50.44 but it seemed a bit too ermmmmm made up lol

If anything falls though. I'll have it.