Board logo

Job lot of new parts
Mr C - 1/1/12 at 09:29 PM

Had a bit of a sort out today and have a few bits surplus to requirements all brand new unless stated

Rubber cotton mounts 40mm dia 39mm high x6 (two modified)
Rubber cotton mounts 32mm dia 18mm high x4
pair of 253 x 10 rear sierra discs (very slight damage to two stud holes due to stud replacement and over zealous tightenng of wheel nuts as seen in image)
Wilwood master cylinder 0.625 bore
large savage engine start switches X2
large black hazard switch

Total cost new over £150

First £50 takes the lot, buyer collects or pays postage costs

Kent/South East London

gavin174 - 1/1/12 at 09:42 PM

yes please

u2u sent

[Edited on 1/1/12 by gavin174]

loggyboy - 1/1/12 at 10:03 PM

2nd dibs

Mr C - 1/1/12 at 10:20 PM

Provisionally sold to Gavin

scootz - 2/1/12 at 10:06 AM

Gavin... if you have no plans for the MC, I'd be tempted to buy it off you.

Cheers

Scott

dave r - 2/1/12 at 10:22 AM

if he does want it, search for landrover master cylinder on ebay, the same shape and sizes but much cheaper than wilwood

scootz - 2/1/12 at 02:14 PM

Cheers Dave!

scootz - 2/1/12 at 02:23 PM

... the LR ones seem to all be 3/4's though. It was a .625 I was after.

Thanks anyway (and great tip for anyone wanting a 3/4 at sensible money!!!).

dave r - 2/1/12 at 04:19 PM

could have sworn that they were 5/8 and 3/4
sorry for getting your hopes up.... but at that price i would be altering pedal ratio's and going with 3/4

Mr C - 4/1/12 at 07:06 PM

Nice to meet you, Gavin all the best with the build, hopefully might catch up on the kitcar show circuit / club scene at some point this year

[Edited on 4/1/12 by Mr C]