I've got a nose come which won't fit my tiger.

£50 plus postage or collection.

See pics.

Has a few scratches but not deep.









[Edited on 27/1/12 by jossey]

[Edited on 27/1/12 by jossey]

What's the width? And what width do you need?

It's from a Haynes roadster locost. Which is 66cm at the back of the cone which attached to the chassis and touches bonnet. And the width of the nose where is drops vertically is 58cm.

Book size as it fit my Haynes and also locost Ron chassis.


I bought a nose cone to fit mine yesterday or £50

If it fits a Haynes then I'll take it. I'll measure up later on just to be sure. Will probably collect sometime if that's OK?

No worries.

It was on my roadster so it defo fits.

I have a bonnet too but with cut out for bike engine (£20)

I can drop it up to my mates in havercroft if better for you.

Cool, that's only 10miles up the road from me Let me know when you're going there next.

I'll probably take the bonnet too, have you got any pics please?

Didn't fit nicks. So they are back up for sale.

£70 nose and bonnet.

Came from Grp panels last year.

If you have a narrower than Haynes car, you can always cut this in half, and refibreglass it together. There is a tutorial on this on here somewhere (widen cycle wings) or something. Also on Kinetic Vehicles website explains how to put a two piece scuttle together. Same principle.

My new car is a tiger so it's shorter and narrower and shallower. So I've bought new panels.