got a trailer to shift, it a big flatbed, would take a large vehicle or lots of pallets etc. Its 213cms wide, or just over 7 foot. Roughly 14 long to the back of the beaver tail but the load cant be on the dropped part due to the axles being central under the flat part, ie if you load the beaver tail it would be too light on the nose.

Only thing it needs is a bed, i have sheets of ply ready cut, that is i believe 5/8ths thick, just needs fastening down. Has a winch but no rope on it!

Has an Alco antisway hitch, and two Alco axles each rated at 1300kgs, so 2600 total, axles were new a few years back.

Tyres have been found flat occationally but hold air for quite a while, ideally needs 4 new ones i think.

Frame been repainted in silver recently.

Looking for £500 ideally, or best offer. Its in leeds.


Originally purchased off this thread, which has pictures:

http://www.locostbuilders.co.uk/viewthread.php?tid=122150



Incidentally, i also have the trailer in the background, but that one needs a new hitch damper.

bump

bump again!