Board logo

new year garage clearout (might not be much use though...)
blakep82 - 1/1/14 at 05:36 PM

Heres some stuff ive collected which i need to shift to make way for my new roll cab tool box

This might not be much use but here goes

Ive got what I believe is a Dana 30 axle and its from a 1986 for aerostar. I believe the dana 30 was used in some jeep wranglers, plenty of lsd and locker parts available. This one has an open diff though
Its had a few bits welded on, but easily removed. Offers for this, its not been used in over 10 years, but there were no shady noises off it

Gearbox from the same 3 litre V6 ford aerostar (was a ford vulcan engine, which was similar but not the same as a taunus engine) got the bell housing too, again no nasty noises from it last time it was used. Offers

The vulcan engine itself, which I quite like to have hanging about, but if anyone has a use, I might let it go. Was used in ford ranger pick ups, not sure if it was in uk models though. Again was quite a solid engine last time it ran. No smoke or anything, but really a rebuild project. Offers

BMW E30 coupe drivers door in dolphin grey, bit of a dent to the bottom corner. £30 plus courier for this really.

BMW E36 328 gearbox. Bought as a spare but never actually used it. Was offered it for 80 so I bought it, even though I didnt really need it. Somewhere around 60 for this I think?

Ive also still got the 328 itself... would make a good donor. 145k miles on it I think? Its got bbs split rim alloys needing a refurb and an lsd. Only got a simple sensor fault, but I couldnt find out which, and I was out of work and couldnt afford to run it, so it sat on the drive and I lost all interest in it. Laquer is peeling off, body isnt great, so donor is its best chance. I'd always had it in my head I'd want something like 600 for it all, but tell me what you think.


raptor700 - 2/1/14 at 01:08 PM

u2u sent

thanks


blakep82 - 5/1/14 at 03:51 PM

Bump, still all for sale