I have a pinto injection engine for sale. This was fitted in car I bought recently. I have a throttle bodied zetec engine going in. All works as it should. £500
Engine was rebuilt a few years ago but has done very few miles. Injection system and loom included.

Ad from when I bought it

Engine was fully rebuilt by Component Engineering of Hapton (cost £1,258.70) including:

Strip and clean head and block in acid bath and with steam lance, fit new bronze guides, centre cam bearing, re-cut valves and seats, mild porting and polishing, re-surface face, re-assemble head including new Kent FR34K cam and vernier pulley. Re-bore cylinders, fit new KS pistons, fit new rod buttons, fit new big end bearings, polish crank, fit new oil pump drive, fit new water pump, rebuild with new gaskets, fit head with new head bolts, cut out and reposition oil filler at back of cam cover. Paint engine in 2-pack red, supply and fit serpentine belt kit, set timing and vernier, supply and fit new AP racing clutch and cover plates, machine lighten and balance flywheel.

[Edited on 3/7/14 by andygfc]

Where abouts are you based?

Mark.

I'm in Kent
Can send on pallet

[Edited on 3/7/14 by andygfc]

Hello ,

please let me know if this does not sale to MsD.

Gerardo

Some pics of engine

http://locostbuilders.co.uk/photos.php?action=showphoto&photo=100_3244.JPG

http://www.locostbuilders.co.uk/photos.php?action=showphoto&photo=100_3242.JPG

http://www.locostbuilders.co.uk/photos.php?action=showphoto&photo=100_3239.JPG


[Edited on 4/7/14 by andygfc]

Bttt

Hi did the engine sell? not confirmed but dad may need a new engine in his old robin hood

Engine SOLD