FS: Gear linkage Rose Joints
We were going to use these on our Phoenix paddle shift but ended up going the cable route. FOUR M8 rose joints with stainless adaptors for fitting to
gear linkage rods. All RH thread. The hole in the end of the adaptor is 4mm, the side holes about 3mm. We were going to drill the ends to accept 5mm
rods and weld them on. They could just as easily be threaded, maybe with LH threads to facilitate adjustment. Thread on rose joint is 25mm long.
Adaptor portion is 38mm long. No locknuts.
Must be of use to someone.
£20 including post. Cheque or PAYPAL gift.
[img]http:// [/img]
[img]http:// [/img]
[img]http:// [/img]
Is this a TRADE ADVERTISEMENT?? Click HERE to report it!
|
