As far as I can tell from the picture in the Sierra manual, what I need is the bracket that bolts (2) to the inlet manifold on the runner nearest the bulkhead and converts the cable motion to rotary maotion, and has a short shaft that carries that motion to the carburettor.

Happy to pay any reasonable amount and postage

Thanks in anticipation

John

i searched hi and low for one of these for the xflow ended up bending some plate for the bracket part and 90deg bend in some 6mm bar welded some pieces onto the bar for the cable to attach to
works a treat if not concourse

chris

ive got the bracket, sorry no linkage bar though, but like the last post just bend a bit of threaded bar. I am only in Dunstable - free if you collect or £10 posted.

let me know

cheers

quote:

---

Originally posted by smalltalk
ive got the bracket, sorry no linkage bar though, but like the last post just bend a bit of threaded bar. I am only in Dunstable - free if you collect or £10 posted.

let me know

cheers

---