Board logo

Wtd: Trigger wheel
dhutch - 1/6/09 at 09:56 PM

Anything considered.
- Will be going on a CVH, but can mod/weld to suit.

Cheap as possable, condition not an issue along as its not bent etc.



Daniel

RichardK - 1/6/09 at 09:58 PM

cvh already has one or do you need 2 for something special

Cheers

Rich

dhutch - 2/6/09 at 08:54 AM

quote:
Originally posted by RichardK
cvh already has one or do you need 2 for something special

Where now?

I have heard of CVHs with 36-1 patterns in the flywheel, but i dont have. And 1.8cvh sierra's with them on the aux belt, but i dont have that either.

RichardK - 2/6/09 at 01:00 PM

It was the 1.8 I was thinking of, so its either go and get a shiney one from triggerwheels.com or the scrappers for a 1.8 one and slice off the pulley bit. I did the later and its been fine.

Cheers

Rich

dhutch - 7/6/09 at 09:22 PM

Yep, i know on on here has one knocking around im going to something of ebay (£12-15ish) and see what i can make of that.
- Turn a very small step into the pressed pulley i have and then tack weld it on and see how it shapes up.



Daniel