I'm looking for the last few bits for my 8" rear drum set-up (as fitted to 1.6 saloon sierras).
Basically I need the brace bars that sits between the shoes, and the levers that connects the cable end to the shoe, as shown here:


[img]http://www.flickr.com/photos/96661824@N00/4431657594/[/img]

Anybody got anything knocking about?

Cheerio,

Rob

I have a pair of 9 inch drums, backplates and all the 'gubbins' and springs - I have converted to discs so no longer needed.

Drums and one back plate have been cleaned up and painted black, one hasn't as below but works o.k.

Don't know if the gubbins fit but the whole lot is just sat on a shelf.

I would imagine postage could be about £20 but may help you out.





[Edited on 14/3/10 by big-vee-twin]

I could measure the gubbins if you want to send me some dims - if you can, then you could just have them rather than every thing if they fit.

Thanks for the image-linky-help Richard, did try to get it to show properly but ran out of time; had to get out in the good weather and get building!

Thanks for the offer Mr BVT, fairly sure the 9" adjuster mechs aren't swapable into 8" drums. I'll keep seaching for a bit, but might be in touch later on if i draw a blank on the 8"?

The search goes on..... Anyone know of any 1.6 sierras in scrappies in the NW?

Mr BVT, yhm (U2U).

Cheers,

Rob.