Board logo

WTD: Pinto Timing Cover Bolts and Washer
ash_hammond - 8/3/12 at 01:23 PM

As the subject.

The 'special' bolts that screw into the engine that the timing cover bolts to.

Cheers

Ash

[Edited on 8/3/12 by ash_hammond]

rash12 - 8/3/12 at 01:25 PM

what do you want ?

scootz - 8/3/12 at 01:26 PM

I hope it's a MG KV6 engine...

ash_hammond - 8/3/12 at 01:26 PM

Fat fingers pressed the enter key before i had finished.


quote:
Originally posted by rash12
what do you want ?

jollygreengiant - 8/3/12 at 03:25 PM

6mm bolt, a washer (large-ish if possible) and then the end off of an air-line coupling (female) cut to the right length (as a sleeve, I think you can just get two, if you are VERY careful, out of one air-line end IIRC).


Edit bit

How do I know, I've dropped/lost one on a saturday/sunday when I've wanted to finish a rebuild/install and everywhere else is shut. In those days I even used to keep the broken ends of the bayonet airline fittings. Oh and I would even replace the damaged/spit rubber grommets with small wiring grommets.

[Edited on 8/3/12 by jollygreengiant]

Andy S - 8/3/12 at 07:19 PM

If I say £10 for a pair posted - pretty sure there are only two - then someone is bound to come along with a free pair - however if they dont you can always come back with a counter offer of sufficient value to make it worth my while digging through the "special" bolts box to find them. I know they are there amongst the funny rocker cover washers and bolts etc.

Andrew