
Before I throw myself at the mercy of Ebay or buy a 50m reel from RS, has anyone got some lightweight two core cable so I can extend my speed sensor
cable for my Vapor Dash. I can't see myself spending my hard earned on the correct Trail Tech cable just for the convenience of it having the
correct plugs on the end as I've already stood on the one fitted to the end of the switch cable and crushed it! About 1.5 meters would get the
dash tied to the sensor bolted to my rear subframe.
Cheers, Owelly.
[Edited on 25/4/12 by owelly]
might I suggest maplin, cable by the meter and reasonable cost,.. or some speaker cable? a bit of tv coax, how cheap do you need?
Had a quick look in the stores and no 2 -core, but got some 3-core 0.5mm sq. I could pop a couple of metres in an envelope if it is not too big for
you.
Regards
Jon
Might have some at work but can't check until I'm in tomorrow. Do you get post in Whitby?? 
Cheers guys but I've just spotted tons of the stuff in a box next to my feet........why didn't I think of chopping the cable off one of the dozens of phone chargers/plug top transformers?!
I was going to suggest that !
Sorted !
Regards
Jon
Just make sure it's well screened otherwise you'll be prone to getting interference.
I'' have a look this afternoon we use miles of Screened cable at work for instruments should be some two core, be very thin so low current.
Can send out FOC
Andy
S'OK Andy. I have it sorted now. It's a shame I've lost the fecking magnet now! It'll be stuck to something.
quote:
Originally posted by owelly
It's a shame I've lost the fecking magnet now! It'll be stuck to something.
Nah, my head is made of jam. The original cable doesn't appear to be screened so I'm hoping it'll be ok. Not that there's much electricity in the car anyway!