Guys,

I am looking for a sheet of ally to make a longer than standard cooker hood chimney from, our kitchen ceiling is very high and the telescopic affair that is supplied with the hood is only a maximum of 77 cm long and I could do with it being another 10cm longer to allow me to drop the hood height down to a more pleasing/effective height.

My father in law has the facilities at work to form the sheet into the correct shape but if he orders the material through work there is a minimum 120cmx240cm sheet size.

If you have any then it must be in mint condition on one side.

What have you got, how much do you want for it and where are you located?

I am in Telford, Shropshire but could travel for the right piece.

Colin

[Edited on 13/5/12 by locoboy]

Guy is advertising this on wscc if any good


Offcut from larger sheet I bought to fabricate a few things for my megablade



970 x 1180 x 3mm



1 edge could do with squaring up slightly



Still has protective plastic on both sides



Sheet this size would cost £45+ from metal merchant

Buyer can book their own courier to collect at their own risk



Cash on collection preferred ( CV47 1GT )



Any questions just drop me a pm



£30

[Edited on 13/5/12 by CRAIGR]

Cheers Craig,
I will see what else comes up...
Colin

No worries Colin.

I have a nice piece in the garage but it might be a little thin it is only 1mm.