Board logo

WTD: gearstick gaiter ring 2"i.d 3.5"o.d.
James - 29/6/12 at 07:15 PM

After a gearstick gaiter ring ideally in stainless to match handbrake but ali would do I guess.

6 hole counter sunk would be even better!

Needs to be 2" I.D. hole and no more than 3.5" O.D.


Anyone got one for sale or know where I can buy one that size?

thanks!

James

James - 4/7/12 at 02:09 PM

Anyone know where I can get one of about these dimensions?

I can't be the only person who doesn't have a 6" wide prop tunnel!

Cheers,
James

Westy1994 - 4/7/12 at 03:15 PM

I think I would be tempted to make my own if you can't find an off the shelf one, or try a metalwork shop, can't cost that much for such a small thing surely?.

Steve Hignett - 4/7/12 at 08:42 PM

I've probably got a couple pieces of carbon somewhere that you can have if you want them?

James - 4/7/12 at 11:37 PM

quote:
Originally posted by Westy1994
I think I would be tempted to make my own if you can't find an off the shelf one, or try a metalwork shop, can't cost that much for such a small thing surely?.


Yeah, I make my own I guess. I wanted something machined so it looks A1.

I have some 2 or 2.5mm ali that would do I guess.

Cheers,
James

James - 4/7/12 at 11:37 PM

quote:
Originally posted by Steve Hignett
I've probably got a couple pieces of carbon somewhere that you can have if you want them?


Very decent of you to offer- thank you!

Will see how it goes with the ali I have if nothing buyable turns up!

James