Im after a pulley with 20mm hole center that i can mount on my axle to connect to the drive unit on this build can any one help??

Also a pillow block or bearing mount for the axle if anyone has got one?

http://www.locostbuilders.co.uk/forum/7/viewthread.php?tid=174891

[Edited on 30/9/12 by Krismc]

You could use a small wheel with the tyre removed.

Actually thats what ive done for the drive end, ill take some pics.

Ill take a look on ebay then.

[Edited on 30/9/12 by Krismc]

Cant find nothing on ebay, ill go take some pics of what i need.

I've a Picador 2 3 4 5 inch stepped pulley, the hole will need machining and the pulley is straight from cating so will need a light machine all over to remove the fash.

You can have it for the postage cost, if its any good to you?

Cant machine anything or weld for that matter, i need a part where all it needs is cutting, filing, grinding or bolting in place.

here is the car as is.... I either need one pulley or replace both.





[Edited on 30/9/12 by Krismc]

I've used these several times for bearings etc. Very good and usually next day delivery.

http://simplybearings.co.uk/shop/

Im still wondering where to get a 20mm bore pulley from. anyone got a one lying around that i can bash the bearing out off.

[Edited on 1/10/12 by Krismc]

How about this?

RDGTOOLS ALUMINIUM 4 STEP V PULLEY WITH A 20MM BORE | eBay

Fit one on the motor and another on the axle the opposite way round to get optimum gear ratios?

Perfect apart from the price, it's a 1/5 locost so I expect 1/5 locost prices. 5er max.