Hi as above, have found a motor to convert a 3 phase lathe to single phase

need a pulley something like the above to fit the motor, it has a 5/8 inch diameter shaft, 3/16 key way with 1 1/2 inches of shaft protruding beyond the motor bearing case.
I suspect something from an old pillar drill might suit but we haven't any knackered ones lying about
Thanks
Mike

When I motorised a set of slip rolls I used Taper Lock fittings. ( eBay, or engineering supplier )

You buy the centre to fit the shaft and the outer to fit whatever you need, in your case, a pulley of a suitable size.


HTH
Paul G

Cheers, thought I'd see if my luck was in first, before pursuing other routes
We have a few other lathes and a trained turner here s he could prob rustle something up but he's away at moment
atb
mike

Sorry. I obviously misunderstood your original post.

Please accept my apologies.

Paul G

Hi Paul , on the contary thanks for responding as there wasn't loads of detailin my post and no one on here has psychic powers !!
We are hoping to sell the machine in question so if we can sort up a. Pulley it is less of a project for someone taking it0on atb
Mike