Hi guys,

Looking for a pinto inlet manifold for my twin webers, it needs to lift the carbs up slightly however so they go over the chassis, kind of looks like this (crude drawing ) hopefully somebody might have one knocking around?




Matt

Bump - Or if anybody knows where i can get one of these for under £100?


Matt

Hi Matt

Have you thought about buying component parts and getting an ali welder to put them together for you?

2 X ALI DCOE FLANGE

+

ALI PINTO FLANGE

+

LENGTH OF ALI TUBE which you can cut into four runners each with the desired angle.

Should come in around £80 for the parts... (not sure how much a friendly welder would charge).