Board logo

Mild Steel Bends - 35mm od
Jamesc - 3/2/14 at 12:47 PM

As above really

Any one have any, have access to a bender or know a good place to buy them?

Thanks!

nick205 - 3/2/14 at 01:07 PM

Can't help, but if you put your location in your profile it might help locate someone local to you.

Jamesc - 3/2/14 at 01:10 PM

Good shout.. Thought I had, but obviously not!

Minicooper - 3/2/14 at 01:53 PM

I've just got some tube bending done by these people, they charged £10 per bend plus material for a custom roll cage hoop and were quick to deliver. Off the shelf stuff was cheaper


www.tube-bender.co.uk

David

nick205 - 3/2/14 at 02:41 PM

quote:
Originally posted by Minicooper
I've just got some tube bending done by these people, they charged £10 per bend plus material for a custom roll cage hoop and were quick to deliver. Off the shelf stuff was cheaper


www.tube-bender.co.uk

David


David,

I thought you had a tube bender?

Minicooper - 3/2/14 at 03:10 PM

quote:
Originally posted by nick205
quote:
Originally posted by Minicooper
I've just got some tube bending done by these people, they charged £10 per bend plus material for a custom roll cage hoop and were quick to deliver. Off the shelf stuff was cheaper


www.tube-bender.co.uk

David


David,

I thought you had a tube bender?



I do Nick, but I didn't have a die for 44.5mm tube, it was easier and a lot cheaper to get the bends done in this case, the bends cost £40 (4 x £10) and the die set was close to £300

Cheers
David