blakep82
|
| posted on 19/4/09 at 08:20 PM |
|
|
WTD, 1.9" exhaust bends
needing to modify my intake manifold, its already made of mild steel, but i need to alter the angle of the tubes, not sure what angle bends, 90 degree
maybe? i can probably make 2 runners out of each one.
anyone got any? ebays turning up stainless steel and all the wrong sizes.
I'll measure again, but i think its 1.9" (49mm is the od of the carbs)
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
|
|
tul214
|
| posted on 19/4/09 at 09:29 PM |
|
|
2" anygood?
http://www.merlinmotorsport.co.uk/EXHAUSTS-Jetex-Exhaust-Parts-2-Inch-Diameter-Mild-Steel-Parts/c223_224_225_2669/index.html
1.6 Raw Super6 sold
|
|
|
blakep82
|
| posted on 19/4/09 at 09:54 PM |
|
|
ah, nice one! they might just do! prices are pretty good too. ebays was something silly like £10-£15 each.
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
