joemotion
|
| posted on 27/5/09 at 05:40 PM |
|
|
Slimline square(ish) fog light
Right i am in the process of lowering my foglight as sva is sorted (looked stupid before) and could do with a slimline foglight - preferably square to
go with the rear rectangular lights. anybody know where to look or has one lurking at home?
I have a landrover one i think fitted at the mo and it is cracked
|
|
|
|
|
Humbug
|
| posted on 27/5/09 at 06:01 PM |
|
|
I've got a spare square one - not especially slim though. Let me know and I will get a pic if you want
Cheers
Simon
|
|
|
chris_smith
|
| posted on 27/5/09 at 06:26 PM |
|
|
i used the 206 fog light they are always popping up on ebay for very little just need to fibreglass some brackets to the inside.
.jpg)
The secret of success is to know something nobody else knows."
|
|
|
joemotion
|
| posted on 27/5/09 at 06:26 PM |
|
|
yeah if u can put a pic up that would be good mate
i also quite like the look of the carbon effect round ones but not sure it will go with rectangular lights
|
|
|
joemotion
|
| posted on 27/5/09 at 06:28 PM |
|
|
its need to be external - i am going to remove the large bracket on mine and either fit direct to the car (will be worng angle) or will trim down the
bracket to suit
quote:
Originally posted by chris_smith
i used the 206 fog light they are always popping up on ebay for very little just need to fibreglass some brackets to the inside.
|
|
|
twybrow
|
| posted on 27/5/09 at 07:44 PM |
|
|
I have the same light as you, and I used the bracket that came with it, and stuck it to the inside of the back panel with a bracket I made up. It sits
at the right angle for SVA, and I can adjust it both up and down, and for angle.
[img][/img]
|
|
|
joemotion
|
| posted on 27/5/09 at 08:31 PM |
|
|
that looks nice - not sure i can face cutting into the bodywork - what trim have u used round the edge?
|
|
|
Vindi_andy
|
| posted on 27/5/09 at 08:45 PM |
|
|
CBS do a surface mount one that is 115 by 80 mm by 58 mm deep
|
|
|
twybrow
|
| posted on 27/5/09 at 11:44 PM |
|
|
quote:
Originally posted by joemotion
that looks nice - not sure i can face cutting into the bodywork - what trim have u used round the edge?
It was traumatic cutting the panel, but I am pleased with the result. I used the small round beading (~7.5mm o/d) with a slit in it. Cant think
exactly where I got it (its not the Woolies stuff as I found out today!).
|
|
|
Humbug
|
| posted on 28/5/09 at 11:56 AM |
|
|
It's this one (or one the same... I've actually got 2!).JPG)
|
|
|
