Charlie_Zetec
|
| posted on 30/5/11 at 10:17 PM |
|
|
WTD bolt-on driveshaft
I'm looking for a bolt-on driveshaft suitable for 3.62 Sierra LSD.
Only need the one, and doesn't have to be in good condition as I plan to strip down and overhaul.
Ideally in or close to Essex, but may consided further afield subject to postage costs.
Thought I'd ask here before trawling eBay....
Artificial intelligence is no match for natural stupidity!
|
|
|
|
|
mcerd1
|
| posted on 30/5/11 at 10:22 PM |
|
|
which side ? - they are different lengths
I've got both, but only 1 pair of CV's for them - I'm about 400miles away though 
[Edited on 30/5/2011 by mcerd1]
-
|
|
|
matt_gsxr
|
| posted on 30/5/11 at 10:33 PM |
|
|
Which side, as above, different lengths, but also the CV into hub has different threads.
|
|
|
Charlie_Zetec
|
| posted on 30/5/11 at 10:40 PM |
|
|
Should've gone into more detail really!
I stripped down my driveshafts for an overhaul, but the joints aren't up to scratch. I had one shaft N/S with a sloppy (excessively worn) inner
but good outer, and the O/S had a good inner but outer had damaged housing.
I decided to make one good shaft out of everything I had - I assumed all the joints were the same. Have I made a schoolboy error there?
Essentially I'm looking for two joints rather than the shaft itself.
Artificial intelligence is no match for natural stupidity!
|
|
|
mcerd1
|
| posted on 30/5/11 at 10:47 PM |
|
|
all 4 joints are the same on the bolt-on ones [aka lobro's] as far as I know
the only important thing is to fit them the right way round
there is a thin line scribed round the outside of the CV joint - this needs to go to the ends/outsides of the shaft (if that make any sence)
-
|
|
|
mcerd1
|
| posted on 30/5/11 at 10:50 PM |
|
|
oh and this is what I've got spare: (click for a massive pic  )
2 joints in need of a clean (didn't seem to worn to me...)
the 4 copper circlips and the lock washers to fit them
[Edited on 30/5/2011 by mcerd1]
-
|
|
|
snapper
|
| posted on 31/5/11 at 03:50 AM |
|
|
gavin174 has some but may only want to sell a pair, he is in Chelmsford.
I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)
|
|
|
gavin174
|
| posted on 31/5/11 at 07:20 AM |
|
|
hi Charlie
I do indeed have a few sets of bolt on driveshafts, but dont want to split a set
I do however have some spare lobros
let me know if its the complete set up or just the joints you are after
cheers Gavin
http://www.essexkitcarclub.com
|
|
|
Charlie_Zetec
|
| posted on 31/5/11 at 08:30 AM |
|
|
Gavin,
Just after the lobro's - ideally need two ends to make a complete shaft.
Let me know how much you want for them!
Artificial intelligence is no match for natural stupidity!
|
|
|
