T66
|
| posted on 12/4/13 at 04:52 PM |
|
|
T304 - 50mm Bends Needed
Im after some u bends or elbows if anyone has some lying about, u2 me please
Ivan
|
|
|
|
|
Confused but excited.
|
| posted on 12/4/13 at 08:25 PM |
|
|
I'm sure I have some in two different radii. Will check garage tomorrow mate.
I bought quite a few of them to make a manifold but turns out they are too large dia for what I need.
Guess I should have done the math first but hey, it's a learning curve, right?
Tell them about the bent treacle edges!
|
|
|
T66
|
| posted on 12/4/13 at 08:42 PM |
|
|
Im finding most of it a learning curve........eeeek
|
|
|
ashg
|
| posted on 12/4/13 at 10:58 PM |
|
|
316 is better for zorsts
Anything With Tits or Wheels Will cost you MONEY!!
Haynes Roadster (Finished)
Exocet (Finished & Sold)
New Project (Started)
|
|
|
T66
|
| posted on 13/4/13 at 05:34 AM |
|
|
quote:
Originally posted by ashg
316 is better for zorsts
I had only just mentioned this was a learning curve, apart from the better corrosion resistance of the 316 whats the difference ?
|
|
|
