MP3C
|
| posted on 21/11/13 at 11:36 AM |
|
|
WTD. Pinto inlet manifold for dcoe 45s
Hi guys,
Looking for a pinto inlet manifold for my twin webers, it needs to lift the carbs up slightly however so they go over the chassis, kind of looks like
this (crude drawing  ) hopefully somebody might have one knocking around?
Matt
|
|
|
|
|
MP3C
|
| posted on 27/11/13 at 10:33 AM |
|
|
Bump - Or if anybody knows where i can get one of these for under £100?
Matt
|
|
|
scootz
|
| posted on 27/11/13 at 02:28 PM |
|
|
Hi Matt
Have you thought about buying component parts and getting an ali welder to put them together for you?
2 X
ALI DCOE FLANGE
+
ALI PINTO FLANGE
+
LENGTH OF ALI TUBE which you can cut into four runners each with the desired angle.
Should come in around £80 for the parts... (not sure how much a friendly welder would charge).
It's Evolution Baby!
|
|
|
