AdrianH
|
| posted on 30/5/11 at 01:47 PM |
|
|
Anyone with an engine stand local willing to sell cheep? Blackburn'ish
Just wondering if there are any engine stands sat in garages local to Blackburn, needs to support Zetec engine so does not need to be a massive
one.
Adrian
[Edited on 30-5-11 by AdrianH]
Why do I have to make the tools to finish the job? More time then money.
|
|
|
|
|
blakep82
|
| posted on 30/5/11 at 01:52 PM |
|
|
any good?
http://www.locostbuilders.co.uk/viewthread.php?tid=156150
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
AdrianH
|
| posted on 30/5/11 at 01:58 PM |
|
|
Saw that, just did not need the engine crane as I use a hoist?
Adrian
[Edited on 30-5-11 by AdrianH]
Why do I have to make the tools to finish the job? More time then money.
|
|
|
dave
|
| posted on 30/5/11 at 04:40 PM |
|
|
Are you in Blackburn West Lothian? I have one but its over at Mango's place.
|
|
|
AdrianH
|
| posted on 30/5/11 at 06:21 PM |
|
|
No it's Blackburn Lancashire. I can always treat myself tomorrow.
Adrian
Why do I have to make the tools to finish the job? More time then money.
|
|
|
Doctor Derek Doctors
|
| posted on 30/5/11 at 07:34 PM |
|
|
I've spoken to CraigJ about buying the engine stand, crane and load level.
I don't currently need the engine stand though as I have a BEC, so you could buy the stand from me if I buy the lot.
I'm in Derby, which isn't too far.
|
NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
|
BigLee
|
| posted on 30/5/11 at 07:51 PM |
|
|
I have an old bread trolly which I used for my MX5 engine/gearbox. Easy enough to manouver, just can't access sump without lifting. You are
welcome to it if it helps?
|
|
|
AdrianH
|
| posted on 30/5/11 at 08:00 PM |
|
|
Hi Lee, I need access to sump and head for work but thanks for the offer.
Not seen you around, hope to meet up sometime.
Hi Derek, the mileage will add to it so I will just buy one from Machine mart or similar thanks for the offer.
Adrian
[Edited on 30-5-11 by AdrianH]
Why do I have to make the tools to finish the job? More time then money.
|
|
|
40inches
|
| posted on 31/5/11 at 03:49 PM |
|
|
Got one of these you can have cheap, never used.
Machine Mart
About 75 miles away, depending which side of Blackburn you are.
[Edited on 31-5-11 by 40inches]
|
|
|
AdrianH
|
| posted on 31/5/11 at 09:32 PM |
|
|
Picked up this afternoon from one in Bolton. Birthday monies! Now sorted.
Adrian
Why do I have to make the tools to finish the job? More time then money.
|
|
|
