Confused but excited.
|
| posted on 7/4/13 at 10:13 PM |
|
|
Wanted two Conrods
Hi guys, I need a couple of U/S conrods for a little project.
Ideally as near as poss to 7in between big and little end bearing centres.
So if anyone has a couple that they were going to bin . . .
They do not need to be serviceable. Can even be a bit rusty or dirty or from a seized engine.
The only must, is that they must be straight, not bent or twisted and obviously the same size.
Anything form Ford to Jaguar, steel or alloy, doesn't matter.
Any help greatly appreciated, as there isn't much in the way of garages to scrounge from around here.
Tell them about the bent treacle edges!
|
|
|
|
|
Volvorsport
|
| posted on 7/4/13 at 10:21 PM |
|
|
volvo redblock ..... 152mm , got loads ...
www.dbsmotorsport.co.uk
getting dirty under a bus
|
|
|
Confused but excited.
|
| posted on 7/4/13 at 10:58 PM |
|
|
Whizzo! U2U on it's way, just as soon as I can type it.
Where else can you get car parts at this time of night? 
Tell them about the bent treacle edges!
|
|
|
