This is bags cheaper than machine mart


Brand Name
Falcon
Item Code
G190
Product Name
Nibbler
Datasheet
none available
Price ex vat: £22.13

Price inc vat: £26.00

In Stock



--------------------------------------------------------------------------------


Product Description
Cuts without distortion. Fitted in an electric or air powered drill this Nibbler will make straight or curved cuts, burr free, with no distortion to the metal panel. Will cut 2mm (14g) aluminium, 1.5mm (16g) steel [max.], or 1mm (20g) stainless steel by nibbling 3.5mm (1¼8" wide chips. Just the job for removing damaged or rusty car panels. To cut from the centre of a panel, just drill a 13mm (1¼2" hole and insert the cutting head.





And remember the derusting thread well how about a plating kit http://www.frost.co.uk/productList.asp?catID=26



[Edited on 1-3-04 by mangogrooveworkshop]

I bought one of these, it does exactly what it says on the packet. I nibbled out the sides and took them to a local sheet metal chap to put neat long folds on the top edge (bought him a drink later)

Rather than complement me on my expert metal cutting he said "What did you cut these with - a tin opener!"

Don't expect a good finish

i had a machine mart one, it broke within 3 hours, taken to a jigsaw, tinsnips and files now

I bought the MMart yellow one from a stand at Newark show 5 years ago for £25 including 2 spare cutters. I used it to do my bodywork aluminium and my 16g floor and did some of a mates car with it as well. If you oil the cut line it will last ages, more important on ali which is more abrasive than the steel. I still have one cutting die left unused and can get replacements easily from MMart down the road and not by post.

yours, Pete.