Hi,

Has anybody had any trouble getting these mirrors through the SVA? (or can anybody see any potential problems)





https://www.europaspares.com/MIRRORS/EXTERIOR_MIRRORS /E_TECH_F2_MIRRORS___1720CN__3952.html

Cheers
Project7

do they meet the minimum area that the mirror area has to be?

I think the minimum area required is 70mm x 40mm (can someone confirm this please) and these mirrors are 165mm x 78mm.

Must accomodate a rectangle 70 wide x 40 deep and a line parallel to the vertical of 70 so they measure up OK. Might be a problem with the top of the 'top hat' of the mount if it can be touched by the mushroom, thus testable for radius.

Ok, thank you for your help - I'll probably be able to stick on some rubber trim for the SVA. I think I'll risk it.