Hi all,
I'm making some more moulds and want to know to use to seal the surface of the plugs. i made a mould using cellulose paint once, not pleasant.
Ive heard people use 2 pak but i'm not down with the hole toxicity of the stuff.
Is there anything else?
A polish or something?

Have a look on the cfs website, I've been reading and there is a PVA release agent for coating the mould before layup. Some sites use carnauba wax saying it's better if you are reusing the mould a lot.

Saw this very topic recently on an Eskimo forum and.............


Sorry, my mistake,



It was "how to buck a seal"!!!!!!!


I thank you!!!!!!!

whatever tickles your pisser.

wax and lots of elbow grease....pva release is good too.