Hi
this has probably been covered before (sorry if it has), but i'm building a 'book' chassis. i might be able to get hold of mk side and rear panels, and was just wondering does anyone know if they will fit ok or if they willneed modifying
cheers
ian

I think the MK indy chassis is an inch or two higher from the scuttle to the front so the side panels will be different . I might be wrong there but if you take a look for your self on some mk indy pics you should notice this. Im not sure about the rear panel though !

It is about an inch to wide as ive just bought one, no probs just take a lump out the middle

I don't think it is an inch too wide, an Indy is the same width as a book chassis (ie 42".
It is an inch too deep, but a suitable bracket is simple enough to fabricate.
The sides, too are an inch too deep, plus they slope from scuttle backwards - pain to put right.
A sheet of ally is better for a side panel.

Marcus

thanks for the input guys
i think i might look at buying a new set of panels, rather than try and make mk ones fit
thanks again
Ian