If i guiloteen a piece of sheet side ali panel and put it in the folding machine and put a one inch 90 degree folded edge top and bottom - i can simply offer it up to the side of the car and rivet it to the top and bottom rails.

Any problems with this with the sva man?

Engine cover - bulkhead - nose etc will cover any edges and a bit of trim over the arm rest edge will cover the ali edge as well .

Am i missing anything?

thanks

jon

If you cover the top row of rivets, even the sva man can't complain.

bloody hell you live in Burntwood

I live in Cannock

I had to rubber trim my side panels along the top

ta
chris

sounds like a bit of trim to cover up with to me then

cheers.... might get the sides on 'this year'