i have searched high/low and all points in between,looking for L section rubber seal,legs need to be about 19mm long and about 3 mm thick ,needs to be bendable ,any ideas peeps?

I guess you've tried Woolies?

Just had a quick look and found this?

Cheers

Mark

I used a fair bit of that on my build.
It's definately L shaped not L_ if you know what I mean (one of the legs is quite short).
Also its fairly thin rubber (2mm approx).

ive seen the woolies stuff,legs not long enough,dosnt matter too much about having one short leg (pirate joke in there somewhere?) but one leg needs to be 19mm min really,2mm thick will do

Would this one be any good?

http://www.woolies-trim.co.uk/pc-1798-322-rubber-extrusion.aspx

seen that Matt (long time no see btw),its last resort as i dont really want the curved leg

How about this:

http://www.polymarine.com/products/parts-and-accessories/rubber-moulded-components/extruded-l-section/index.cfm

4mm thick though which might be a bit bulky.

Keep trying to make WLM meet but with it only being once a month and quite a long trek these days something always seems to get in the way September looking possible though.