I have these bonnet catches LINKY
But they dont come with fitting plans

Anyone got any plans for me before i make a mess of fitting them!

ATB

Matt

[Edited on 5/12/07 by matt.c]

I didn't get plans with mine either so I guessed with the first one so that the catch was directly above the rubber bit and had it stretch when it was closed about 1/4". seems to work they have not come loose so far while driving.

Caber

hi i have still got the fitting instructions will try email them to you if you like

Try rs, stock code: 288-8464. You want the dimensions for the small ones.



Put the holes 2mm closer together than on that pic, so 29mm not 32mm.

David

hehe beat me to it was strugling to do that

I used the plans from hellfires website, did a test on a lump of wood first worked a treat once you make a template up for holes from the self tappers i used in the wood.Image deleted by owner

Agh - Bob you neat me to it....

Just print the plans....




Regards


Steve

Cool

Many thanks.

I got a scrap of ally sheet and drilled the mounting holes, then tested that the catch worked properly at that spacing (took a couple of goes til I was happy) then i used the ally as a drill guide