No comments please! I'm looking for a small, tear drop shaped bulge (not the big bonnet bulge type things). Does anyone know of any suppliers?
Thanks in advance.

this any good??

Could do with something smaller than what is described as the smaller cod piece. Ideally about 10 to 15 cm long. I've spent the afternoon trawling model aircraft etc sites to no avail.

http://cgi.ebay.co.uk/Car-Cosmetic-6-Air-Scoop-Bonnet-Vent-Carbon-Fiber-Look_W0QQitemZ280229557663QQihZ018QQcategoryZ43118QQssPageNameZWDVWQQrdZ1QQcmd ZViewItem

This any good

I think Redline Components do a teardrop shaped one, thogh the website doesn't seem to list actual products

ummm I have what can only be described as half an easter egg...small bump that is..! more a tear drop type thing

Mark

Smaller than the small cod piece? Can you u2u some dims and a price in carbon please?

Have to measure it tomorrow as it's at work...
Mark

PBV102 12 Inch Teardrop power bulge



12 inches any good?
I suppose it depends on the size of your cod

[Edited on 27-5-08 by RazMan]

Well, I've really walked into this but... 12" is really going to be too big. I could do with something about 6" long. Go on, say it!

How about just cutting a suitable section out of a melon, wrapping in cling film and laying up GRP over that? Then a bit of filler to smooth off the outer surface

Cheers

Fred W B

I could actually make a foam and epoxy plug, an aluminised epoxy mould and then lay up a nice 2x2 twill carbon bulge but my time is better spent on other things at the moment. I guess I just need to get on with it.