shortie
|
| posted on 16/5/05 at 09:37 AM |
|
|
Aluminium Squares
I am looking to get hold of some aluminium sqaures in 4mm thick ali.
I need 10 of 100mmx100mmx4mm and wondered if anyone on here could supply them for me as I know a few of you have access to metal cutting equip.
Obviously happy to pay the going rate and p&p.
thanks,
Rich.
|
|
|
|
|
bigandy
|
| posted on 16/5/05 at 12:23 PM |
|
|
a jigsaw would manage cutting 4mm thick ally.....
Andy
Dammit! Too many decisions....
|
|
|
RazMan
|
| posted on 16/5/05 at 09:05 PM |
|
|
quote:
Originally posted by bigandy
a jigsaw would manage cutting 4mm thick ally.....
Andy
But a Gilly would give a much better edge
Cheers,
Raz
When thinking outside the box doesn't work any more, it's time to build a new box
|
|
|
bob
|
| posted on 17/5/05 at 08:08 AM |
|
|
quote:
Originally posted by shortie
I am looking to get hold of some aluminium sqaures in 4mm thick ali.
I need 10 of 100mmx100mmx4mm and wondered if anyone on here could supply them for me as I know a few of you have access to metal cutting equi
Obviously happy to pay the going rate and p&p.
thanks,
Rich.
Rich
I have a large sheet of 8 gauge ali in the garage,its about 4.something mm thick(cant be bothered to look at the chart) once i've chpped my
bits off for the zetec sump mods you are welcome to take a chunk
[Edited on 18/5/05 by bob]
|
|
|
shortie
|
| posted on 17/5/05 at 11:11 AM |
|
|
That would be great Bob, thanks,
When do you think you will have finished with it?
Rich.
|
|
|
bob
|
| posted on 17/5/05 at 12:51 PM |
|
|
Rich
I can slice a chunk off it tomorow as i'm of shift till thurs,i'll grind a strip just over 1 metre x just over 200mm off and you can tidy
up and chop to your measurements.
It'll look a bit rough with the grinder to chop it but hey its free
|
|
|
ned
|
| posted on 17/5/05 at 01:01 PM |
|
|
i cut my floor out with a grinder (only 1.6mm ally though) and a little bit of filing to take the burrs off and its fine, not rough looking at all 
beware, I've got yellow skin
|
|
|
