johnemms
|
| posted on 1/6/06 at 07:31 PM |
|
|
ali side panel edges - sva
If i guiloteen a piece of sheet side ali panel and put it in the folding machine and put a one inch 90 degree folded edge top and bottom - i can
simply offer it up to the side of the car and rivet it to the top and bottom rails.
Any problems with this with the sva man?
Engine cover - bulkhead - nose etc will cover any edges and a bit of trim over the arm rest edge will cover the ali edge as well .
Am i missing anything?
thanks
jon
|
|
|
|
|
DIY Si
|
| posted on 1/6/06 at 07:35 PM |
|
|
If you cover the top row of rivets, even the sva man can't complain.
|
|
|
zxrlocost
|
| posted on 1/6/06 at 07:43 PM |
|
|
bloody hell you live in Burntwood
I live in Cannock
I had to rubber trim my side panels along the top
ta
chris
|
PLEASE NOTE: This user is a trader who has not signed up for the LocostBuilders registration scheme. If this post is advertising a commercial product or service, please report it by clicking here.
|
johnemms
|
| posted on 2/6/06 at 07:19 AM |
|
|
sounds like a bit of trim to cover up with to me then
cheers.... might get the sides on 'this year'
|
|
|
