Board logo

running megajolt 2d??
Danozeman - 14/12/08 at 12:52 PM

A question for megajolt users.

How do u get the megajolt to run 2d witht he newer config program?

It wont let me set all the load bins to 0.

Also has anyone got a good 2d map for a zetec,

[Edited on 14/12/08 by Danozeman]

BenTyreman - 14/12/08 at 01:08 PM

Can't you just enter the same advance for all loads for a single RPM bin?

Danozeman - 14/12/08 at 01:10 PM

thats what i have done at th minute. Is that how it should be done?

r1_pete - 14/12/08 at 01:54 PM

what engine / carb config are you using?

Werner Van Loock - 14/12/08 at 07:23 PM

quote:
Originally posted by Danozeman
thats what i have done at th minute. Is that how it should be done?


Does it matter? Either way, you get the same advance for all load cells, so it's a 2D map in a 3D environment, just make sure your load cells are so that it doesn't keep jumping up and down, unnecessary stress for the MJ.

Danozeman - 14/12/08 at 10:34 PM

Its a 1.8 zetec with 2 litre cams and zx9r carbs.

paulf - 15/12/08 at 09:03 PM

Ive got a 3d one from my zetec with injection , you could just put the full load figures in all bins.
I will have to dig it out because its on my laptopat present but can find it tommorow.
Do you want a 2d because there is no throttle pot on the carbs?
Paul

Danozeman - 17/12/08 at 12:54 PM

No throttle pot at the minute. But there will be after sva.