Board logo

Dash wiring?
matt.c - 14/1/09 at 09:20 PM

Right first off, sorry but im a complete idiot when it comes to wiring so here goes.
I am using the sierra switch gear for the high/low beam and the hazards(left stalk) and am using the key for the ignition/steering lock.
I want to remove all these and mount switches on the dashboard.

1. starter button and switch for the ignition
2. hazard switch
3. headlight high/low beam switch

How do i wire these up from the standard stuff?

austin man - 14/1/09 at 11:12 PM

are u planning on removing the ignition barrel if so you will create a problem for the SVA as you will not have a steering lock ? you need a means of giving an ignition live via the fuse board so would need some form of ignition which also acts as another security measure..

flak monkey - 15/1/09 at 07:47 AM

Matt, you should have said.

Let me know when you want it doing and I'll pop over and give you a hand.

David

nitram38 - 15/1/09 at 08:41 AM

quote:
Originally posted by austin man
are u planning on removing the ignition barrel if so you will create a problem for the SVA as you will not have a steering lock ? you need a means of giving an ignition live via the fuse board so would need some form of ignition which also acts as another security measure..


A steering lock is not required only two forms of security. This can be two means of electrical isolation such as an fia switch and an immobiliser.

matt.c - 15/1/09 at 09:13 PM

quote:
Originally posted by flak monkey
Matt, you should have said.

Let me know when you want it doing and I'll pop over and give you a hand.

David


Was giving you some time to do your car instead of mine for once lol!! Still trying to decide if to remove the stalks etc or not.