bit of a work in progress this, i've been slowly putting to together to make the wiring a little easier and i found the premier instructions a little difficult to get my head around.

if anyone knows any of this to be wrong, or where wires should go (currently stumped by charge light from the loom should connect, same with oil pressure/warning light)

(See bottom of thread)

[Edited on 27/2/04 by Staple balls]

black/green on my 1.6 pinto goes from the module to the starter wire in the ignition barrel, to tell the module that the engine is cranking. i think! is the black one the normal 'running' live?

i honestly have no idea. at all.

i don't speak wiring

just twigged, going my the other diagrams i have about.

black/green to blue/black (ign switch to starter solenoid) ?

think so! connected mine up like that the other day and it runs ok, cept no vacuum advance on it yet...

good enough for me

finally got it wired up and working (apart from the lights mentioned at the top)

so, have a nice new revision of the diagram in shiny pdf flavour (16k)

clicky

hope this helps someone

[Edited on 27/2/04 by Staple balls]