I have two wires coming from the magnetic sensor that I am using for my Revotec speedo but on the wiring harness for the speedo there is only one wire to connect the sensor to.
Am I supposed to connect both wires from the sensor to the one from the speedo? Im no auto electrician but that seems odd.

The only remaing wires that I have not used are:-

Harness reset switch
Pull up/down
speed signal (hall/ecu)

Im sure these have nothing to do with the magnetic sender.

[Edited on 21/5/05 by cerbera]

1 to the speedo, the other to Earth.

DOH! That should have been obvious.

Thanks.

Or one to +12v and the other to the speedo - that's how my greengauge one works.
Pat...

my telemetrix speedo needed the positive pull up connected to function as well.

my reed switch is a switched earth also.

hth
tom